courtesy of Pamas GMBH
The PAMAS GMBH SBSS particle analysing system is a tried and trusted measuring instrument for laboratory particle counting. Using measuring data provided by fluid samples with known particulate contaminant, PAMAS has proved the repeatability of its particle counting systems.
Comparison of repeat measurements clearly show that the results of different measurements of the same fluid sample scarcely deviate from one another. Many renowned laboratories appreciate the extremely high measuring accuracy of PAMAS particle counters and in turn, manufacturers of conventional particle counters use the PAMAS SBSS particle analysing system as a reference for their calibration.
The repeatability of a particle counter is an important parameter to define the performance of a system. Fluid cleanliness control of water, oil, hydraulic liquids and pharmaceutical suspensions require an accurate measurement of particulate matter. Being a specialist in fluid particle counting, PAMAS develops, manufactures and sells particle analysing instruments for batch and online sampling and for field measurements on-site.
For batch sampling of higher viscosity fluids, PAMAS recommends the PAMAS SBSS particle analysing system. Automatic Particle Counters (APC) are used for contamination control to determine the concentration of particulate matter in fluids. Initial calibration assures the particle counters’ measuring accuracy.
The international calibration standard ISO 11171 guarantees the exact determination of the particle size distribution in liquids. The ISO 11171 calibration standard contains some repeatability statements that compatible systems need to fulfil. ISO 11171 defines the repeatability requirements through the DQ value (DQ standing for Difference in Quantity). So the DQ parameter determines the repeatability of APC measuring results. The DQ value is calculated by the formula: DQ = 100*((max-min)/mean count). For all measurements with more than 10000 counts per size channel, the DQ value is limited to 11% (+/- 5.5%). The limit increases for samples with lower counts. At 100 counts per measurement, the permitted DQ value is 27.5% (+/- 13.75%). Using measuring data provided by fluid samples with known particulate contaminant, PAMAS has tested the repeatability of the PAMAS SBSS laboratory particle counting system.
To calculate the DQ value, a hydraulic oil sample has been measured five times after previous standardised sample preparation. The particles were counted in the size channels > 4 µm(c), > 5 µm(c), > 6 µm(c), >7 µm(c), > 8 µm(c), > 10 µm(c) and > 12 µm(c). The particle counts of all five measurements then were compared in each size channel. The test resulted in DQ values between 0.59% and 5.94%. The test results thus were far below the maximum DQ limit of 11%. For the particle size > 4 µm(c), the DQ value was 0.59%: this corresponds to only 54 % of the maximum DQ limit as determined by ISO 11171.
The test clearly defined the high measuring accuracy and supreme repeatability of the PAMAS SBSS particle analysing system. Besides its measuring accuracy, the PAMAS SBSS laboratory particle counting system further excels due to its ease of use: Equipped with an integrated pre-adjustable sampling mode, the system analyses the sample directly out of the sample container, thus removing the need for the fluid sample to be transferred to another container before measurement which may falsify results due to cross contamination.
Once the instrument is set up to the user specified parameters, the PAMAS SBSS’s operation is reduced to a one button press combined with the insertion of the fluid samples wishing to be analysed. Another benefit of the PAMAS SBSS laboratory instrument is the integrated pressure container. This sample vessel is used to create either high pressure or vacuum. High pressure is applied to transport high viscous liquids through the sensor for measurement whereas the vacuum mode removes gas bubbles out of the sample.